In our test laboratories, all tests demanded under IEC and TSE standards excluding mechanical resistance test against short-circuits can be conducted for our oily distribution transformers, dry type distribution transformers and power transformers.
Our systems:
1. Test area of transformers having 150 MVA power and of which the highest operation voltage is 220 kV.
2. Test area of transformers having 30 MVA power and of which the highest operation voltage is 36 kV.
Transformer Routing Tests:
They are the tests conducted for every transformer produced.
Measurement of voltage cycle rate and control of voltage vector phase shift (TTR test)
Measurement of coil resistance
Test of AC resistance voltage with separate source (Test of applied voltage)
Test of Induced AC voltage (Induced voltage test)
Measurement of idle loss and current
Measurement of short-circuit impedance and loss in the load
Capacity and tan ∂ measurement
Measurement of DC insulation resistance
Transformer Type Tests:
They are the tests conducted on the transformer with the same characteristics on customer demand.
Measurement of noise (volume)
Lightning impulse test
Temperature increase test
If there are fan cooling or liquid pump system, measurement of fan or liquid pump losses
Transformer Special Tests:
There are the tests conducted on the customer demand.
Idle current and measurement of harmonic compounds
Measurement of zero compound impedance
Measurement of partial discharge
Insulation Liquids – Breakdown Voltage Assignment on Power Frequency (measurement of oil dielectric resistance)
Tests of level changer under load
Function and isolation tests of protection, alarm and command equipment
Isolator Test:
Routine and type tests used in transformers;
Power Frequency Voltage Resistance Test in Dry and Wet Condition
Temperature Increase Test
Verification of Thermal Short-Term Resistance to Current
Console Load Resistance Test
Verification of Dimensions
Partial Discharge Test